Working on the First Ball and Claw

Well I did get some time in the shop yesterday and today.  So I made some progress on the first ball and claw foot that I need for the Townsend Card Table.  In the previous post I mentioned that I was going to carve the two feet in parallel.   Well that is not going to work.  I did carve the two feet into cylinders but that is it.  Once I start to carve the ball I have to finish the entire carving,  I can not start and stop halfway through.  
So, I was able to complete the ball and start to work on the talons.  I did undercut the rear talon.  I should be able to finish up this foot tomorrow.
So here is today's video: